Contact 800-639-2901

Dixon® 16P4 DIXV-16P4
  1. pin-int

DIXV-16P4

Dixon® 16P4 Holedall™ Uni-Range External Swage Coupling, 1 in ID x 1-42/64 to 1-46/64 in OD Nominal, MNPT End Style, Carbon Steel, Domestic

  • Manufacturer: Dixon Valve & Coupling
  • Brand Name: Dixon®
  • Part Number: DIXV-16P4
  • MPN: 16P4
  • UPC: 089109711574
  • Min. Order Qty: 1
  • Qty. Interval: 1
  • loading Available at Reynolds & Son, Inc - So Barre

Dixon® External Swage Coupling, Uni-Range, Series: Holedall™, Fitting/Connector Type: Coupling, 1 in ID x 1-42/64 to 1-46/64 in OD Nominal, MNPT, 4-9/16 in Length, Carbon Steel, Plated, Domestic

Domestic/Import      :      Domestic
End Style      :      MNPT
Finish      :      Plated
Fitting/Connector Type      :      Coupling
Length      :      4-9/16 in
Material      :      Carbon Steel
Nominal Size      :      1 in ID x 1-42/64 to 1-46/64 in OD
Series      :      Holedall™
Type      :      Uni-Range
  • Designed for smaller hose systems
  • Shipped complete with factory assembled stem and ferrule combination
  • Can be swaged or crimped
  • Stainless steel stem lengths are investment cast
  • Other hose OD's available, contact Dixon
  • Dixon holedall stems and ferrules are specifically designed to be used together as a coupling system
  • Due to differences in dimensions and tolerances, for safety reasons, do not use other manufacturer's stems or ferrules with Dixon holedall products
  • Do not use a wrench or vice on ferrule
  • Holedall couplings, regardless of coupling style, are never to be used for steam service at any pressure
  • Holedall fittings are not to be used with cable reinforced high pressure hose, 4 or 6 braid wire hydraulic hose or any other service not listed in the recommendations
  • Externally swaged holedall couplings, to perform satisfactorily, must be applied properly in accordance with Dixon's assembly procedures, using correct die and ferrule for that particular hose end OD
  • Dixon's die and ferrule Recommendation guide is to be used to select correct dies and ferrules
  • Hose service working pressure (including surges and spikes) is never to exceed the maximum recommended working pressure for the fitting
  • The assembly's (hose + coupling) maximum working pressure is the lesser of the hose rated working pressure or the coupling rated working pressure
  • Media being transported through the hose should be compatible with the stem material
  • Compatibility of ferrule material with the environment in which it will be used is recommended
  • For applications other than the ones list, please consult Dixon
  • Warning: this product contains a chemical known to the state of California to cause birth defects or other reproductive harm
  • Do not use in connection with drinking water
  • Wash hands after handling